A storage idea for small closets is a project that takes a typical range of rooms, removes existing luminaries and creates a redesigned storage solution. Creating a custom assembled device will ensure that you create enough space to store all of your items. In addition, you may have enough to know where everything is hidden. Similar prefabricated closet systems can cost hundreds of dollars and still do not provide enough space. By measuring and building on these measurements, you are sure to make the most of your space. Remove all clothes and other items from the wardrobe. Take the closet bar and remove the shelf above. Flush the holes in the wall by leveling a thin layer of filler over the holes with flap. Allow the patch to dry completely and flat against the wall. Lay two 72-inch boards side by side on the work surface. Action to find the midpoint of the depths of the boards. Use the straight edge to draw a line directly in the center down the length of the boards.
Storage ideas for small closets, measure and mark from the bottom of the boards 33 inches. Measure and mark from the top of the boards down 12 3/4 inches, 25 1/2 inches and 38 1/4 inches. Use the straight edge to extend the markers all the way across the boards. Repeat with the other 72-inch discs. Place two 72-inch discs on their sides and place a 14-inch board level with each mark between them. Attach the slabs with wooden straps and 2-inch surface nails. Repeat for all 72-inch discs. This will give you three lockers.
12 Photos Gallery of: Best Storage Ideas for Small Closets
Then to make storage ideas for small closets, measure along the side of the cabinets, three inches from the top and make a mark on the center line. Measure 36 inches and make a mark on the center line. Repeat on each side of the cupboards. Raise the cabinet and attach the spout holder to both sides of the middle cabinet and the inside of the cabinet. Slide the cabinet together with a 30-inch gap between them. Install the closet rods in the pan holder. Apply wood kittens to the nail holes and allow drying before grinding. Paint or bet as desired.